How To Fix Remobell S Not Connecting To Wifi

Here are some troubleshooting tips you can try to fix the problem with your Remobell S. Follow these steps one by one:

Step 1: Check Wi-Fi Signal Strength

• Go closer to your Wi-Fi box with your Remobell S.
• Check if the doorbell is close enough to get a good Wi-Fi signal.
• If the signal is not strong, bring the Wi-Fi box closer or use a Wi-Fi booster.

Step 2: Restart Your Router

• Turn off your Wi-Fi router.
• Unplug the router from the power source.
• Wait for 30 seconds.
• Plug the Wi-Fi box back in and wait until it is completely turned on.

Step 3: Look for anything that might be causing problems with the Wi-Fi.

• See if there's anything around your Remobell S or Wi-Fi box that might be causing trouble for the Wi-Fi signal. This could be things like microwaves, phones without wires, or baby monitors.
• See if you can turn off or move these things somewhere else to stop them from causing problems with the Wi-Fi.

Step 4: Install the newest software for your device.

• Open the Remobell app on your smartphone.

• Check if there are any available firmware updates for your Remobell S.

• If an update is available, follow the instructions to put the newest software on your device.
  

  1. Open the Remobell app on your smartphone or tablet.
  2. From the main menu, select your Remobell S device.
  3. Tap on the "Settings" or "Device Settings" option.
  4. Look for an option labeled "software Update" or something similar.
  5. If a new software update is available, you will see a notification or instructions to download and install the update.
  6. Tap on the "Update" or "Download" button to start the process.
  7. The app will download the latest software version for your Remobell S.
  8. Once the download is complete, you will be prompted to install the update.
  9. Read and follow the on screen instructions carefully.You may be asked to keep your Remobell S connected to power and near Wi-Fi network during the installation process.
  10. Do not stop the update or turn off your Remobell S until it is finished install on the new software.
  11. The app will show when the new software update has been successfully.
  12. After the update is complete, your Remobell S may reboot automatically or instructions to restart it manually.

Step 5: Reset Remobell S

• Find the reset button on the back of your Remobell S. It is usually a tiny hole.
• Get a paperclip or something like it. Push and hold the reset button for a few seconds until you see the LED light blink.
• After resetting, use the Remobell app to set it up again and reconnect it to your Wi-Fi.

This video provide how to reset Remobell s device

Step 6: Check Wi-Fi Password and Security Settings

• Make sure to enter the correct Wi-Fi password.
• Check Wi-Fi box has any special security settings turned on disabled that may be causing problems with the Remobell S.
• Look at the documentation that came with your Wi-Fi box or contact your internet service provider for assistance with security settings.

Step 7: Contact Remobell Support

• If none of above steps fix the problem, reach out to Remobell S customer support team for more help.
• Tell them exactly how you have set everything up, what you have done to try to fix it, and if you have seen any messages or noticed anything unusual.

By following step by step you can figure out and fix the Wi-Fi connectivity issues with your Remobell S smart doorbell.